CELEBRATING 30 YEARS OF EXCELLENCE IN THE DEFENSE AND COMMERCIAL COMMUNICATIONS INDUSTRY
Showing all 11 resultsSorted by popularity
he 0700-9151 Dual Hot Melt Epoxy Oven was specifically designed for the U.S. Marines. The oven has a shut off feature that will turn off the oven after two hours. The oven has a warning indicator light built into the cover to warn the Warfighter that the oven chassis is too hot to touch or…
The 0700-3055 Jacket Strip Tool was designed from input by the Warfighters to enable them to easily strip and remove the outer jacket of the M85045/8A TFOCA II® ruggedized cable. Two op- posing razor-sharp blades sink just deep enough to split the tough jacket without damaging the buffer, tangling the Kevlar, or harming the fiber.
The 0731-1210 TFOCA II® Splice Enclosure Nut Wrench allows the end cap to thread completely onto the connection fitting on the TFOCA II® Jacket Protection Sleeve (JPS-400).
The 0731-1170 TFOCA II® TFOCA Splice Enclosure (JPS-400) was designed by KITCO Fiber Optics and the U.S. Marine Corps to allow the Warfighter to properly protect the M85045 Tactical Fiber Optic Cable after it has been spliced. This extremely rugged yet completely flexible jacket protection sleeve assumes the contour of the diameter of the fiber…
The 0700-4610 Flare Nut Wrench is used to remove the strength member wedge pack from the strain relief housing inside the TFOCA II® connector.
The 0700-4625 Plate Insertion and Removal Tool (PIRT) is used to insert and remove the insert from the TFOCA II® connector receptacle
The 0731-1132 Spring Compression Install and Removal Tool (SCIRT) is used to insert and remove the termini from the retaining plate for TFOCA II® connectors.
The 0700-4620 TFOCA II® Spanner Wrench is used to insert and remove the insert nut from the TFOCA II® connector receptacle.
The 0703-3740 Cleaver is a companion product to the Corning 0703-3745 Pretium® Unicam® Installation Tool. The Corning Pretium® ST, SC, and LC style connectors are usually referred to as No Epoxy, No Polish (NENP) products. These connectors are set with epoxy and “factory polished” which results in extremely low dB loss. An index matching gel…
The 0703-3740 Cleaver is a companion product to the Corning 0703-3745 Pretium® Unicam® Installation Tool. The Corning Pretium® ST, SC, and LC style connectors are usually referred to as No Epoxy, No Polish (NENP) products. These connectors are set with epoxy and “factory polished” which results in extremely low dB loss. An index matching gel…
uses Accessibility Checker to monitor our website's accessibility.
WidgCo BackPack and KSE Kit TFOCA II®
WidgCo BackPack and KSE Kit Expanded Beam
Portable OTDR, Cleaning and Inspection Backpack Kit
Pigtail Consumable Replacement Kit
Universal Splice Kit and Termination/Fusion Splice Kit
Military/Commercial Termination Kit
Military/Commercial Inspection, Cleaning, and Test Kit